Learning to make spritesI was looking through the contents of the cassette that came with the ... Read More!
Amstrad 3.5" Floppy drive - DSK to DiscSo you've got the floppy drive all powered and plugged in, but got no Amstrad CPC software on 3.5" d... Read More!
Amstrad Controller PCB'sIt's been a while since I last posted, yet again. I've been paying a fair bit of attention to the we... Read More!
Connecting a 3.5" floppy drive to an Amstrad 464 without modifying the drive or DDI-1Quite some time ago I bought a DDI-1 interface to use with my amstrad 464's. Just the interface with... Read More!
Amstrad 3.5" Floppy drive - Making a new ribbon cable, case and switchesSo if you've followed the previous blog posts about making a PC 3.5" floppy drive work with your Ams... Read More!
Amstrad Controller STL files
Created on: 22-04-2019 By Gee
I mentioned a while back that I was going to share the STL files so you can make the Amstrad controllers at home (if you have a 3d printer). So here they are!
I wanted to make sure I had the correct files as I had made several versions. This was due to testing several things then forgetting to write down which ones were the ones that worked best.
These files MUST NOT be used for making and selling the controllers under any circumstances. The designs are all my own work and belong to me. I am releasing them in good will to help the Amstrad community make their own controllers as they helped me and continue to do so with several things.